*** LHSS WINCHESTER 1866 & 1873 GUN PARTS ***

Long Hunter Shooting Supply is a federally licensed dealer and manufacturer.

The Grabber ©. This sight utilizes a Marble's ® sight base and a large diameter bead. This sight gives your riflea more "period correct" presentation and allows customization of sight height from .370" to .500". Bead diameters are available in .130" or .175". Bead material is brass. Grabber sights are now in use by over 200 shooters, including End of Trail and Winter Range champions, regional and state winners, and black powder specialists. Order a Grabber sight today -You won't believe how well your rifle times will improve!

The SliXprings replaces the heavy stock lever and lifter springs. These redesigned and engineered set of SliXprings provide a smoother, trouble free competitive replacement lever spring kit. Minor fitting may be required. Complete instructions and hardened screws included. These are the most durable, long lasting springs on the market.

Replaces the stock firing pin with the newly designed and alloyed firing pin and spring. The design incorporates an engineered radiused shoulder that all but eliminates those broken pins. The alloy is MIL-SPEC the same as the M-16 and aftermarket AR-15. Minor fitting may be required. The pins are designed a little long so they can be fitted properly to each individual rifle. Complete instructions included along with a new firing pin spring.

These new stainless followers will not rust in the tube like stock followers.

This spring will work in rifles of any caliber, and in barrel lengths of 24" or shorter. Will not rust the way your stock magazine spring does. In barrel lengths shorter than 24 inch, the spring is inserted in magazine and cut 3 inches long outside of tube for proper tension.

We offer two different short stroke kits from Pioneer Gun Works for your M1866 or M1873 Winchester. Complete instructions included with every kit.

• The standard kit will shorten the lever travel of your rifle by about 1 3/4" - 2".
• The super short stroke kit was designed to be the shortest SASS legal short stroke kit you can buy. It's slightly longer than the SASS minimum to make sure your rifle is SASS legal.

Machined from 6061-T651 aircraft quality aluminum and hard anodized for toughness and long life. Weighing only 1.0 ounce, it is about 1/4 the weight of the stock Uberti brass carrier. Designed with all the clearance you need for installation with either short stroke kit.

This spring replaces the flat safety spring for the disconnect (trigger block). The reduced tension allows the trigger to function as designed but gets rid of the annoying down pressure on the lever. Without the disconnect installed, the rifle can fire before the links are fully extended. Stay safe and leave the disconnect in the rifle.This is the same spring we use in all our 1873 action work. Easy installation.